Thermoelectric installation Warm Stream-1VP

One of the factors complicating the operation of downhole equipment in most of the fields is the high content of asphaltenes, resins and paraffins, as well as the increased viscosity of the produced fluid, which leads to well failure, the need to perform their premature workover and an increase in production costs. "Is intended for thermal action on the fluid in order to reduce its viscosity, prevent ARPD and hydrate formation along the bore of oil production wells and freezing of water in artesian and injection wells. The main task of the unit and the main difference from other heaters is the controlled maintenance of the temperature of the produced fluid flow by 3-5 degrees above the temperature of oil saturation with paraffin. At the same time, the power consumed by WARMSTREAM-1VP is significantly lower than the power that would have to be applied to melt the wax. 1. "WARM STREAM-1VP" with placement outside or inside the tubing. It is successfully used in oil wells to prevent the formation of asphalt-resinous and paraffinic deposits (ARPD) on the walls of tubing by increasing the temperature of the produced fluid, as well as in water intake and injection wells in order to prevent freezing. 2. "WARM STREAM-IN" induction type, is used on oil and water wells, flow lines, for heating Christmas trees and wellheads, as well as outlets from AGSU and oil-gathering reservoirs of various diameters located in areas with cold climates in order to prevent equipment freezing and produced fluid. The installation is characterized by minimal power consumption with a high efficiency, a good alternative to self-regulating cables. This equipment has proven itself and is successfully operated at the fields of PJSC Gazprom Neft, PJSC NK Rosneft, PJSC LUKOIL, PJSC NK RussNeft, Kazakhoil Aktobe LLP, Sistema-Service Group of Companies LLC, Novatek-Tarkosaleneftegaz LLC, Ukrnafta. The main advantages of using WARM STREAM installations: -high reliability in extreme conditions; -fast payback; -increase in the cleanup and turnaround time of the well ; -continuous heating of the well along the interval of deposits; -rejection of similar methods of dealing with paraffin; -heating of the transported fluid from the well and into the well; -reduction of the load on submersible pumps and pumps for oil production. Those. specifications On request. Detailed information in the presentation.